This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problems installing 220... Help please!

Hey All...

I'm experiencing difficulties connecting to the internet during the initial set up process for the Astaro 220.

Here's a connection diagram: DSL modem/line --> eth1 port. eth0 port --> switch --> pc for webadmin

Here's what I've done so far, maybe some steps are missing and maybe some are wrong, but that manual hasn't been able to help me. Your help is appreciated.

I've set up a "Standard Ethernet Interface" on eth1 , entered static IP, entered static netmask, entered static default gateway. everything else is to "OFF" position, MTU @ 1500.

Then, I activate the interface (green light), refreshed and still have NO INTERNET.

What OTHER steps do I need to take to set up basic internet access to my network? I cannot seem to get it going...

The Macromedia Breeze tutorials all stop in the middle of the demo's which also makes it difficult to configure properly.

Your help is appreciated!

Thanks,

Kris.


This thread was automatically locked due to age.
Parents
  • The help file is a PDF.

    There are 2 steps missing from your setup.
    1/. create filter rule allowing your "internal network" "any" "any" "allow"
    2/. create a MASQ rule internal network to external interface.

    That will get your basic firewall going until you learn what other security functions you want to enable.

    Ian M
Reply
  • The help file is a PDF.

    There are 2 steps missing from your setup.
    1/. create filter rule allowing your "internal network" "any" "any" "allow"
    2/. create a MASQ rule internal network to external interface.

    That will get your basic firewall going until you learn what other security functions you want to enable.

    Ian M
Children
No Data