This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

low values on network graphs

My network graphs show traffic levels far below the actual levels. For two physical ports that are in bridge mode, the graph shows 1 to 10kbps while mrtg on the upstream router shows 200 to 3500kbps which I believe to be reasonably accurate.

Astaro support says this is normal. Anyone else seen this? Why would it be 'normal'?

Alan

This thread was automatically locked due to age.

Parents

0 drees over 19 years ago

Simon is correct, it's because of averaging. If you sustain high bandwidth for an extended period of time, it does plot as expected.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 drees over 19 years ago

Simon is correct, it's because of averaging. If you sustain high bandwidth for an extended period of time, it does plot as expected.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 alehman over 19 years ago in reply to drees

I think it's something other than averaging because my router MRTG runs 30 minute and 2 hour averages. The difference between mrtg and astaro is quite large.
Cancel
Vote Up 0 Vote Down

Cancel
0 drees over 19 years ago in reply to alehman

Ah, totally missed that you are graphing traffic with MRTG and comparing it to Astaro's charts. I'm not sure what the problem is, then, I use cacti (which uses mrtg) to plot traffic on my firewalls and they match up with the firewall exactly.
Cancel
Vote Up 0 Vote Down

Cancel