This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG320 interface connections

It seems to me that interface eth0 from a ASG320 device must be used to internal connections as stated in the manual. However, does the same rule apllies to the other interfaces? Can I connect the internet to interface eth4 and DMZ to eth3 for example? Or do I need to connect any outside connections to eth1 and the DMZ to eth2?
Thank You
Pedro

This thread was automatically locked due to age.

0 ReD-MaN over 19 years ago

The other interfaces can be used for whatever you want. There is no pre-set rules or anything on those.
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 19 years ago in reply to ReD-MaN

Ahh yes.. they are totally flexible in how you use any / all of those ports.. the only thing to know is that after a factory reset, eth0 has the address 192.168.0.1 ...

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel