This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPoE-ADSL 900 seconds to reconnect...

Dear All,

I've seen that this question was already asked...but I cannot find if there was a solution about it...

the 900 seconds waiting time when the ADSL line goes down and ASG cannot reconnect immediately...can be changed?

15 minutes to re-attempt a connection is too long! Usually the interruption should not last that long... I would like to set this down to 30 seconds or 1 minute maximum...

Any idea?

Thx!
Dave

This thread was automatically locked due to age.

0 florian over 19 years ago

H Dave,

just edit the following lines in /var/chroot-pppoe/bin/DSL.sh to the values you want

# timeouts in seconds
MINTIME=60
ACRETRY=900
PPPOERETRY=900

Florian
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 19 years ago in reply to florian

Thank you. I have been searching for the same answer for a while.
Any ideas on what the minimum you could go to eg 5 for eacxh entry without causing the system too much grief. Most networks have automatic re-connect on failure so the down time to users is almost transparent. I realise under a true fault condition the log would fill up very quickly, but that is th eexception rather than the rule.

Ian M [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 florian over 19 years ago in reply to RFCat_vk_01

Hi Ian,

I operate with the following settings:

MINTIME=60
ACRETRY=10
PPPOERETRY=60

It works quite fine for me.

Florian
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 19 years ago in reply to florian

Florian,
thank you. I will give them a try tomorrow and see what happens.

Ian M [:)]
Cancel
Vote Up 0 Vote Down

Cancel