This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cant connect to webmin (new install)?

Ive installed Astaro v6 and it installs just fine but when I try to connect to the webmin page its fails and i can not ping the address either. My setup is a p3 933 1.5gb ram 2nics.
I have dsl but it was not connected to the astaro machine at the time the setup was astaro -> Cisco 2950 switch -> machines. The server was set to be 192.168.0.1 and then i set up a satic xp machine with 192.168.0.10. I did an ifconfig on the astaro machine and it was verified that it was the right ip and i tired to ping from there and it didnt work so I changed swaped the wires in the nics restarted and still didnt work.... (I have clarkconnect working just fine on the same machine now???) What did I do wrong. I also tried to puting the astaro and a laptop on its own cisco hub with the laptop ip of .10 also and still didnt work i guess it doesnt like me or someting

Any suggestions would love to play with astaro and see what its all about.

This thread was automatically locked due to age.

Parents

0 GeekyMalarkey over 19 years ago

I also find that including the port in the url tends to help with the performance of the WebAdmin app. You can get away without using it, but I found that I would lose my session often when I did not include it.

Instead of https://192.168.1.100, try https://192.168.1.100:443 (you can change the port once you are in the app, if you like).
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 GeekyMalarkey over 19 years ago

I also find that including the port in the url tends to help with the performance of the WebAdmin app. You can get away without using it, but I found that I would lose my session often when I did not include it.

Instead of https://192.168.1.100, try https://192.168.1.100:443 (you can change the port once you are in the app, if you like).
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data