Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 4721 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Speed and Duplex setting

ksn
How to change/set speed and duplex setting om ASL 6.x.  I have a Via PD10000 miniITX card with dual NIC.  The type III card works find, but the type II have no/bad performance.  I have tried to connect to different Switch/hub but no changes.


This thread was automatically locked due to age.
Parents
  • 0
    Hey KSN,

    you can set a Speed with

    mii-diag -F 100baseTX-FD eth0

    you would like on boot
    go to joe /etc/init.d/boot
    insert a mii-diag line before #distribute timezone link to all chroot

    Have a nice Day
  • 0 in reply to privatuser
    However, there could be different problems with the nic driver on asl. if mii-diag won´t work, try

    ethtool 

    for example

    ethtool -s eth0 speed 100 duplex half


    you can also make an entry in the /etc/init.d/boot if you like to keep this setting after reboot your appliance.

    hope this solution is ok for all. kind regards

    joerg
    (tsystems international, sysadmin)
Reply
  • 0 in reply to privatuser
    However, there could be different problems with the nic driver on asl. if mii-diag won´t work, try

    ethtool 

    for example

    ethtool -s eth0 speed 100 duplex half


    you can also make an entry in the /etc/init.d/boot if you like to keep this setting after reboot your appliance.

    hope this solution is ok for all. kind regards

    joerg
    (tsystems international, sysadmin)
Children
No Data
Cookie Information Banner