The installation goes good for version 6 and 5.1 of Astaro; however, once the install is comlete and it prompts for a reboot this is all I get at the prompt:
L 02 02 02 02 02 02 02 02 02 02 02 02 02 ..... and so one.
There are about four lines of this, then it stops and nothing happens--unit hangs
I tried to install either of the version in classic mode, same thing.
I did have linux installed on this pc before with no issues.
I checked out this link:
http://www.wlug.org.nz/LiloErrorCodes
--Address mark not found: This usually indicates a media problem. Try again several times.
I have tried several times.
Any other suggestions other then check bios and do the LBA large.---which it is set all ready.
Thanks in advance.
This thread was automatically locked due to age.