This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Once install is complete-error on reboot--L 02 02

The installation goes good for version 6 and 5.1 of Astaro; however, once the install is comlete and it prompts for a reboot this is all I get at the prompt:
L 02 02 02 02 02 02 02 02 02 02 02 02 02 ..... and so one.
There are about four lines of this, then it stops and nothing happens--unit hangs
I tried to install either of the version in classic mode, same thing.
I did have linux installed on this pc before with no issues.
I checked out this link:
http://www.wlug.org.nz/LiloErrorCodes
--Address mark not found: This usually indicates a media problem. Try again several times.

I have tried several times.
Any other suggestions other then check bios and do the LBA large.---which it is set all ready.

Thanks in advance.

This thread was automatically locked due to age.

0 RFCat_vk_01 over 20 years ago

I let the bios do it all on "auto", seems to work fine.

Ian M [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 jaxk66 over 20 years ago in reply to RFCat_vk_01

Thanks for the suggestion.
In bios the HDD was on Auto but I switched it again to LBA, Large for the v5.1 install and it worked this time.
I also selected in the bios to load bios defaults and then changed the HDD to LBA to Large.

I am trying the v6 install right now to see if it will work also. [;)]

Once again thanks for the suggestion and all who viewed this.
You can consider this post closed.
Thank you.
Cancel
Vote Up 0 Vote Down

Cancel