This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation Problem

HI

I just installed astaro and it went quite smooth till I removed the CD and rebooted (on request). The system comes up normally, but then it hangs with the following massage:

INIT: version 2.82 booting
INIT: No inittable found

Enter runlevel:

Where does this error come from and how can it be fixed?

This thread was automatically locked due to age.

Parents

0 SecApp over 20 years ago

Presuming the media is good (no smudges on the CD, CD reader solid, etc.), it's time to start playing with the BIOS settings and reinstall (APIC, etc.)

Are you using a SATA disk?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 SecApp over 20 years ago

Presuming the media is good (no smudges on the CD, CD reader solid, etc.), it's time to start playing with the BIOS settings and reinstall (APIC, etc.)

Are you using a SATA disk?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 train over 20 years ago in reply to SecApp

[ QUOTE ]
Presuming the media is good (no smudges on the CD, CD reader solid, etc.), it's time to start playing with the BIOS settings and reinstall (APIC, etc.)

Are you using a SATA disk?

[/ QUOTE ]
I'm not using SATA. What settings should be changed in the BIOS? And with what opptions should I reinstall the system?
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 20 years ago in reply to train

APIC relates to the power off settings.

Go through all of the settings and make them "conservative"...
Cancel
Vote Up 0 Vote Down

Cancel
0 train over 20 years ago in reply to SecApp

[ QUOTE ]
APIC relates to the power off settings.

Go through all of the settings and make them "conservative"...

[/ QUOTE ]
Well, it's all set to normal/conservative....nothing special there at all. Maybe some hardware is broken?
Cancel
Vote Up 0 Vote Down

Cancel
0 train over 20 years ago in reply to train

Ok, I now just installed without APIC option and the problem is still there....help [:(]
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 20 years ago in reply to train

IDE or SCSI?
What controller?
What motherboard?

Barry
Cancel
Vote Up 0 Vote Down

Cancel