This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to restore a backup with [5.008] or [5.010]

I was unable to restore a backup from [5.008] to a fresh install of [5.008] or a backup of [5.010] to a fresh install of [5.010]. 
I applied the backup, waited 15 mins., but was unable to access Webadmin. I rebooted Astaro from the console but even after that I could not access Webadmin. The computer is a PIII 667 with 256MB of Ram and 3 NICs. 

The hardware has been the same for the last year and has been running [5.011] just fine (until it crashed due to a power outage) so I doubt its hardware related.

I WAS able to reinstall [5.010], configure it from scratch, and get it running correctly. 
Should I apply my Licence before I restore a backup ? I tried it but it did not seem to help.
I checked the NICS after restoring the backup and they were set correctly as to eth0, eth1, and eth2.

Has anyone encountered problems restoring backups with 5.0? Could it be that with the HTTP Proxy and IPS turned on (in the backup) that 256MB of RAM is no enough to restore a backup? Maybe? 

Any ideas?

Dan


This thread was automatically locked due to age.
Parents
  • This may be unrelated to your issue, but I've run into problems when restoring a backup using FireFox.  There seems to be an issue with how files get uploaded in FireFox 0.9.xx which has wiped out my ASL box on 3 different occasions (each requiring a clean install).

    However, applying the backup from IE 6 has worked flawlessly.

    I now restore the backups with IE 6, but do all other managing thru FireFox 0.9.1.  

    Good Luck!
  • I DID  restore the backup using Firefox.....
    I will use IE next time. Thanks for the info!!!

    Dan
Reply Children