Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 2 subscribers
  • Views 1100 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASL won't quit rebooting

frankske_
I installed V4.0 on a P3 866 with 128MB and 10GB.  
I previously ran V3 on it without any problems.  
I did a clean install of V4 but now it won't boot properly.  Each time it comes up to the point where it says
'Filesystem check running - please standby', it reboots.  
I reinstalled W2K on it, and that runs fine so I don't think it's a hardware problem.  I reinstalled V4, added an other 128MB but the results is always the same.  It just keeps on rebooting.  Also removing one of the 3 nics didn't help.
Any clues?

Frank


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Dennis Koslowski
    ok, thx, I'll give it a try!
  • 0 in reply to frankske_
    I also had this on a Poweredge 650 (P3 800) I thought it was the HDD as well, but when I had it open I was looking at the entire system board and noticed the Heatsink was on at an angle! Whipped it off, cleaned it off and put it back on (the right way round this time!) and its been fine ever since.

    This was how the machine was supplied and it had been working fine, but our server room hadn't ever been so crowded or hot before and I think it just pushed it over the edge.

    One to check. Overheating, especially this time of year.
Cookie Information Banner