This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Second ISP

This is a frustrating one. I am adding a second ISP to astaro. I set up the Standard ethernet interface with static IP. etc as soon as I enable I am unable to access the first eth1 ip address. Any thoughts?

This thread was automatically locked due to age.

Parents

0 SecApp over 21 years ago

What do you want to do?
Load Balance?
Send all request for one network or networks out one interface??
Cancel
Vote Up 0 Vote Down

Cancel
0 gnursey over 21 years ago in reply to SecApp

I want to bring both ISP in parallel then eventually remove one.
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 21 years ago in reply to gnursey

Stock, you can only have one default gateway (or "route of last resort") going to the 'net. You can hook up two, but it will only send packets out the one not the last by means of designated networks on your routing page. Fancier stuff has to be done through command line...
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 SecApp over 21 years ago in reply to gnursey

Stock, you can only have one default gateway (or "route of last resort") going to the 'net. You can hook up two, but it will only send packets out the one not the last by means of designated networks on your routing page. Fancier stuff has to be done through command line...
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data