Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 2 subscribers
  • Views 1161 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After installation ->boot -> 01 01 01 01 01 01 01

555
Problem as follows,

after installation (everything ok there), booting the computer and then screen goes just "01 01 01 01 01 01..." and doesn't seem to do anything. What might cause the problem ?

Thanks for help.   


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to SecApp
    Setup as follows:
    Intel Pentium 4 / 2.4GHz
    512 RAM
    HD Seagate 13Gb (main HD is bigger, but when installing FW,  this smaller was the only HD connected)

    still I am quite curious, what is causing the system halt ?

    I was browsing through some older posts, where was similar problems and the problem was caused by HD configuration, would it be the case here aswell ?

    Still, help needed, not too nice way to start product evaluation, ok, installation went nice, other wise, I don't know... [:S]
      
  • 0 in reply to 555
    I f I got you right you have now two drives connected. If yes remove the second disk since Astaro supports one only. SecApp meant to set the HDD operation mode to normal, not LBA, Fast Mode or whatever. 

    Greetings
    cyclops  
  • 0 in reply to cyclops
    I've experienced the same myself. Changed HD settings in BIOS from AUTO to LBA mode

    hope that helps! 
Cookie Information Banner