This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro 4.008 Installation Troubles

I'm new to Astaro software. I installed 4.008 and the installation went fine. I then rebooted and the screen goes through the bios initialization and then it says "LI". Any help would be appreciated. Thanks

This thread was automatically locked due to age.

Parents

0 SecApp over 22 years ago

Try the Search next time.

That appears to happen because of BIOS settings (using APM, etc.). Making your settings more conservative should remedy the problem...
Cancel
Vote Up 0 Vote Down

Cancel
0 DMan over 22 years ago in reply to SecApp

I did use the search button. I disabled the power management and I still have the problem
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 22 years ago in reply to DMan

Well, that worked for somebody else, and you didn't mention that you had tried that.

Any other settings we can make conservative? Sound? Plug and Play?

At the end of the day, one of your hardware components might need a Linux driver that ASL doesn't have preloaded on the install CD. With name brand hardware, that circumstance is becoming less frequent, but it still happens from time to time...
Cancel
Vote Up 0 Vote Down

Cancel
0 DMan over 22 years ago in reply to SecApp

Thanks for the hints, I'll continue to dig around.
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 22 years ago in reply to DMan

By the way; the LI is probably "LILO" getting tuncated; the machine is locking up when the drivers are coming online...
Cancel
Vote Up 0 Vote Down

Cancel
0 Overnet over 22 years ago in reply to DMan

Try to download the new ASL iso and install it. See if your problem go away. Here is the link to the new iso of ASL.

ASL 4.016
Cancel
Vote Up 0 Vote Down

Cancel
0 Vukasin over 22 years ago in reply to Overnet

the "LI" on the screen means that the stage 2 of LILO did not load. You can boot a live cd (gentoo maybe) and check the lilo configuration (make sure you mount and chroot to your ASL system).
also search google for possible stage 2 failures in LILO (and your config)

good luck.

P.S. reinstalling the LILO to MBR might be a good ideaa too.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Vukasin over 22 years ago in reply to Overnet

the "LI" on the screen means that the stage 2 of LILO did not load. You can boot a live cd (gentoo maybe) and check the lilo configuration (make sure you mount and chroot to your ASL system).
also search google for possible stage 2 failures in LILO (and your config)

good luck.

P.S. reinstalling the LILO to MBR might be a good ideaa too.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data