This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation Problem / Boot from HD

Hi,
i've got a problem installing/running AST4. Installation from the CD works fine, but than, starting the system from HD does not. After bios-checks the monitor shows a continous stream of "01 ". Keyboard is active (Numlock) but the system doesn't boot from HD. I've got a Pentium III, 666 MHz, 512 MB RAM and a new IDE 80 GByte WesternDigital Disk.

Any ideas?

Stephan

This thread was automatically locked due to age.

Parents

0 sschulz over 22 years ago

I just found the error, it was a lilo-message and by switching off the power-management in the lilo-conf everything works fine.

Stephan
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 22 years ago in reply to sschulz

Thanks for sharing that; I think I saw that problem on another post; now we know...
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 SecApp over 22 years ago in reply to sschulz

Thanks for sharing that; I think I saw that problem on another post; now we know...
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data