This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NICS that don't work in V.4

I have 2 nics that the v 3.2 install recognized, but when I install v4, it doesn't recognize either of them.  Is anyone aware of this problem, or these particular nics?

eth0   3Com Corporation 3c905 100BaseTX [Boomerang]
eth1   National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller

eth1 is a netgear nic.

Any help is greatly appreciated.

This thread was automatically locked due to age.

Parents

0 MSeaton80 over 22 years ago

Thanks for the info. I couldnt install from the v4 disc, so I did the migration, changed the 3com nic to "vanilla-3c59x" and system came up fine. I am still having problems with the Netgear FA311 nic....ASL doc site says it works, but I have read other user posts saying it doesn't.

If anyone knows of the correct driver to use for the FA311, it would be appreciated. I was using "alias eth1 natsemi"
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 MSeaton80 over 22 years ago

Thanks for the info. I couldnt install from the v4 disc, so I did the migration, changed the 3com nic to "vanilla-3c59x" and system came up fine. I am still having problems with the Netgear FA311 nic....ASL doc site says it works, but I have read other user posts saying it doesn't.

If anyone knows of the correct driver to use for the FA311, it would be appreciated. I was using "alias eth1 natsemi"
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data