This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro + Dell + Cmd680 Controller = Slow Perf

I installed astaro on a Dell PowerEdge 680 which comes with a CMD680 controller but I have got slow performance because of PIO mode access to the Hard disk. Astaro correctly detected the controller and the hard drive but it doesn't enable the DMA mode on it.
I have tried to use ide0=dma as append parameter but nothing changed.
Any ideas ?

Thanks

This thread was automatically locked due to age.

Parents

0 netplace over 22 years ago

We have the same problem on a dell PE 650. Boot Time is around 10 Minutes.
using_dma=0 in /proc/ide/hda/settings
Performance is not very bad
is it possible to force the dma mode somehow?
Cancel
Vote Up 0 Vote Down

Cancel
0 Pikkio over 22 years ago in reply to netplace

I just worked around uploading a static hdparm to my box and changing /etc/rc.boot/boot file (I added the "hdparm -d 1 /dev/hda" at the begining).

Hope Astaro Team will fix this.
Cancel
Vote Up 0 Vote Down

Cancel
0 netplace over 22 years ago in reply to Pikkio

I did this too today. Copied the hdparm from a redhat 7.3 box to ASL and edited the etc/rc.boot/boot with

/sbin/hdparm -d1 -c1 /dev/hda

Problem is Fixed.

Thanks to Astaro Admin Oliver Desch.
Cancel
Vote Up 0 Vote Down

Cancel
0 oliver.desch over 22 years ago in reply to netplace

HI alltogether,

I have copied 'hdparm' to www.n-zsolt.de/downloads, please see also the readme file.

read u
o|iver
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 oliver.desch over 22 years ago in reply to netplace

HI alltogether,

I have copied 'hdparm' to www.n-zsolt.de/downloads, please see also the readme file.

read u
o|iver
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data