This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

eth1 still down

I've a problam, because the eth1 of my Astaro security linux is alwase is down. I can configure it as a dhcp client or with static ips.
the eth0 is up and i can connect to the webinterfase. If I start it with "ifconfig eth1 up" it dos not display the ip, and in the webinterfase ist still down. I changet also the NIC but doesn't work.

This thread was automatically locked due to age.

Parents

0 LinuxVirgin over 22 years ago

I have this problem each time i add a new ethernet interface.
i am assuming you have are already connected etc...

Most of the time after i have enabled the interface if i close my browser and open again it is ok. Or I just try to enable again and it works.

Note also that there is a time delay involved before it is up.
Cancel
Vote Up 0 Vote Down

Cancel
0 studi4 over 22 years ago in reply to LinuxVirgin

No it does no go up, also if i wait for 10 min, or if i close the browser. If I start the computer and make a ifconfig, there is only a eth0 and a lo.
Cancel
Vote Up 0 Vote Down

Cancel
0 orhan over 22 years ago in reply to studi4

more details of hardware and software version pls
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 orhan over 22 years ago in reply to studi4

more details of hardware and software version pls
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 studi4 over 22 years ago in reply to orhan

ASL v. 4.009 AMD K6-II 400MHz, 128 MB Ram, 3Com, Realteak, Intel, SMC NIC's I have change them, 13 GB HDD.
It's only the eth1 witch still down. In /etc/wfe/conf/itf.conf is the status of eth0 1, the status of eth1 is 0, but if a but it on 1 then i cant connect to the web interface. I also get in ip from the dhcp.
Cancel
Vote Up 0 Vote Down

Cancel