This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ethernet interface - enabled, but reported as down

using webadmin, i configured eth3 as 192.168.2.1/24 with gateway=none (standard ethernet interface), enabled it, but it's reported as down (though the light is green).
also, address/netmask are displayed as ???.???.???.??? in interfaces list

i even tried editing /etc/wfe/conf/itf.conf by hand - i added an entry
for eth3, copying most of the settings from the other, working card (eth2).
but interface isn't being brought up, addr/mask are again ???.???.???.??? in interfaces list in webadmin
the hardware is ok - plain "ifconfig eth3 192.168.2.1/24" does what i want
i hope astaro fix its' bugs pretty soon. also, with 4.008 update, all my network cards are displayed as unknown vendor/unknown device (they work, though) (in 4.007 they were correctly identified). some new bug?


This thread was automatically locked due to age.
Parents
  • I am using ASL4.008  and I had this same problem when I first setup my ASL system at home, but it occured after I changed the IP address on my first network card to a different IP scheme. After changing the IP address of the card webadmin reported ???.???.???.??? for all of my network cards IP's. Everything that I changed would not remedy this problem. Finally I reloaded everything from scratch with the new IP scheme and everything has been working fine since.   
Reply
  • I am using ASL4.008  and I had this same problem when I first setup my ASL system at home, but it occured after I changed the IP address on my first network card to a different IP scheme. After changing the IP address of the card webadmin reported ???.???.???.??? for all of my network cards IP's. Everything that I changed would not remedy this problem. Finally I reloaded everything from scratch with the new IP scheme and everything has been working fine since.   
Children
No Data