This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Eth disables

Hi @All,

I yust have a IBM X305.
I installed ASL4.0. All fine.
But after enabling the 2.nd Eth (onboard)
all eth-Ports disable against outside.
Internal (Console) they are running with ping etc.

Has anyone a idea?

Greatings
Joachim Hubinger

This thread was automatically locked due to age.

Parents

0 Suppentrulli over 22 years ago

Hi,

could you give us more details? network, subnet-mask etc.
Cancel
Vote Up 0 Vote Down

Cancel
0 Hubinger over 22 years ago in reply to Suppentrulli

Hi Suppentrulli,

Sorry been inexact.
I just set up both cards in the same range.
192.168.100.1 255.255.255.0
192.168.100.2 255.255.255.0
I did, because i want to check which eth-port belongs
to which connector.

Maybe one thing :
When i set up the system new, i choised the Card with
IRQ5 to bee the managing port.
After starting the system again i got first access and
the eth0 was set to IRQ7, which was the second card.
I checked that twice to bee shure not to have set up the
wrong card-port.

BR

Joachim
Cancel
Vote Up 0 Vote Down

Cancel
0 KKnecht over 22 years ago in reply to Hubinger

Hi hubinger,

NERVER setup 2 different ethernet cards within the SAME subnet !!!
How should your firewall know where to route the packets ?!?!?

Use as an example:
192.168.100.1 255.255.255.0
192.168.101.1 255.255.255.0

Karsten
Cancel
Vote Up 0 Vote Down

Cancel
0 Suppentrulli over 22 years ago in reply to KKnecht

That's it. [;)]
Cancel
Vote Up 0 Vote Down

Cancel
0 Hubinger over 22 years ago in reply to Suppentrulli

Ok Ok,
I have it

Thanks a lot..

BR

Joachim
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Hubinger over 22 years ago in reply to Suppentrulli

Ok Ok,
I have it

Thanks a lot..

BR

Joachim
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data