This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't Browse to ASL to complete install

After I did my install, I got a message to remove to CD, reboot and browse to the administrative IP address to complete install.

Well I removed the CD, I rebooted.  On the console I can see the Root login propmt.  I can PING the admin IP address.

I cannot 'browse' to the IP address.

I have tried both http://address and https://address

Any tips?

Oh, currently the box only has 64Mb of memory.  The additional memory will not come until monday....

This thread was automatically locked due to age.

Parents

0 Joe_Halleck over 22 years ago

Insure your pluged into the right hub with the admin interface and your workstation.
Cancel
Vote Up 0 Vote Down

Cancel
0 Bob M over 22 years ago in reply to Joe_Halleck

[ QUOTE ]
Insure your pluged into the right hub with the admin interface and your workstation.

[/ QUOTE ]

I did say I can ping it (meaning the admin interface, as that is the only IP address entered during install).

I did not say that I am accessing it from a system on its subnet, ensuring that there is nothing between me and the firewall.
Cancel
Vote Up 0 Vote Down

Cancel
0 Bob M over 22 years ago in reply to Bob M

New install works just fine. So does the new 4 port card!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Bob M over 22 years ago in reply to Bob M

New install works just fine. So does the new 4 port card!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data