This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problems to establish PPPoE

Hi
I have a problem to configure pppoE.I turned my ADSL Zyxcel 642 Router to Brigde Mode and then i tried to configure the Internet Interface with pppoE.When i finished configure,in Menu Network - Interfaces - the Internet Interface loooks like

Parameters ????????/???????? and the Interface doesn't comes up.Why?
Any ideas whats wrong?

This thread was automatically locked due to age.

Parents

0 jader_01 over 22 years ago

Is your zyxel a router or a modem?
if it's a router, you have ethernet between ASL and your zyxel, not PPPoE.

Erik
Cancel
Vote Up 0 Vote Down

Cancel
0 ASL_Beginner over 22 years ago in reply to jader_01

Hi Erik

Yes my Zyxel is a router Mod. 642R.My Problem is that i have only 8 Public IP Adresses.What else can i do to If i will use all IPs in my DMZ ?

Now i use 1 IP for the router 1 for ASL Internet Interface
In the second Subnet i use 1 IP for Dmz Interface and 1 for Webserver. So i loose 4 IPs for infrastruktur :-((

But i'am sure there is a better way! :-))

ASL-Beginner
Cancel
Vote Up 0 Vote Down

Cancel
0 jader_01 over 22 years ago in reply to ASL_Beginner

There is an ugly thing called 'proxy arp' ...
or try virtual interfaces and DNAT

Erik
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 jader_01 over 22 years ago in reply to ASL_Beginner

There is an ugly thing called 'proxy arp' ...
or try virtual interfaces and DNAT

Erik
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data