This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Tulip NIC drivers

Hello ASL,

sometimes we're using NIC's from KTI with an Intel/Dec Chip. Your installation routine detects them as "tulip" and installs the needed module. But the NIC's don't apear in WebAdmin and are not visible with ifconfig.

We did replace the module tulip.o with dx450.o (or something like that, I'm writing this from scratch) in modules.conf and now they work fine.

Is it possible to change your way of hardware detection to better recognize the "right" module? I don't like booting with an emergency cdrom, mount the volumes and edit modules.conf by hand, I'm a lazy person

Thanks,
Boris Halter

This thread was automatically locked due to age.

Parents

0 boris_01 over 23 years ago

I forgot a small detail: without changing the module the ASL Box crashes with the next reboot (for example the first reboot after installation)
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to boris_01

Hello Boris,

first of all, wich ASL version do you use?

to change HD detection I need PCI ID of the card (the second column in /proc/bus/pci/devices)

Thank you,
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel
0 boris_01 over 23 years ago in reply to Dennis Koslowski

Sorry for laming :-((

New ASL 3.50 support the nic's as designed.

Boris
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 boris_01 over 23 years ago in reply to Dennis Koslowski

Sorry for laming :-((

New ASL 3.50 support the nic's as designed.

Boris
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Tulip NIC drivers

Submitted a Tech Support Case lately from the Support Portal?