This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Adding Third NIC

I know there have been postings about this before, but I want to install a new nic in the firewall.

Question: How can I force the new nic to be eth2?

Is there a way to re-initiate qmail-install? I would like to reconfigure the whole qmail system.

This thread was automatically locked due to age.

Parents

0 KKnecht over 23 years ago

- Save your active configuration
- Re-Install the ASL from the CD
The new card should be recognized
- Restore your configuration
- Configure your new eth2
Cancel
Vote Up 0 Vote Down

Cancel
0 Marius over 23 years ago in reply to KKnecht

Why not just put in the NIC and do the config with the webadmin? This is how I did it.
Cancel
Vote Up 0 Vote Down

Cancel
0 Morten B. over 23 years ago in reply to KKnecht

How can I be sure that my new nic is numbered eth2?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Morten B. over 23 years ago in reply to KKnecht

How can I be sure that my new nic is numbered eth2?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 ollion over 23 years ago in reply to Morten B.

KKnecht,

you were right, no plug and play after installation.
To install a additional NIC without reinstalling ASL
you need to know the responsible driver and to add
it in /etc/modules.conf.
I think a reboot is the fastest to activate the new
settings.

regards
ollion
Cancel
Vote Up 0 Vote Down

Cancel