Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 598 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation problem

K Hansson
Hi!

This may be a stupid question, but here goes anyway.

I have just installed ASL 2.0 on a machine with ASUS CUV4X m/b and DLink DFE570TX tulip-based 4-port network card.

During installation I selected standard values for IP 192.168.2.100, 255.255.255.0, 192.168.2.1.

Then I took a crosslink cable and connected eth0 to a workstation configured as 192.168.2.2.

During boot the ASL machine detects all four ports of the DLink card and everything seems normal, but I cannot access the machine from the workstation using ping or IE 5.5.

Any suggestions on what to check?


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to oliver.desch
    On your workstation, ensure that the default gateway set to 192.168.2.100 instead of 192.168.2.1.

    Also, I had problems with several different NIC's, including Netgear, D-LINK, and Linksys single port cards. You may want to try using either a 3Com 905 series or the Intel card to see if the card itself is the issue.

    [ 27 December 2001: Message edited by: Larry Cody ]

Unfiltered HTML