Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

2.0 install

Just a wild guess... did you clear the ARP cache on your computer? If not, your computer will remember the ip-address of the old firewall ALONG with it's MAC address...
It's a long shot though, as I think the ARP cache doesn't live very long.

Did you try logging on to the console executing either of the following:
"netstat -nr"  - shows routes
"ifconfig" - config of interfaces

and of course, pinging your workstation and your default gateway (if any) from the firewall.

Good luck!

Ørjan Sandland


This thread was automatically locked due to age.
Parents
  • Hello all, 
    Yesturday I set up a machine identical to our 1.793 Astaro firewall, I installed 2.0 FINAL on it and imported a fresh backup (from the 1.793 box). The backup imported succesfully and everything seemed fine; however when I droppped this machine in the old ones place and booted it up, nothing happened. It would not pass any routes, and I was unable to connect to it via webadmin or any other interface.
    Do I need to type in the config by hand for this kind of upgrade?
    Any ideas would be GREATLY appreciated.

    Thanks,
    Ryan R.
Reply
  • Hello all, 
    Yesturday I set up a machine identical to our 1.793 Astaro firewall, I installed 2.0 FINAL on it and imported a fresh backup (from the 1.793 box). The backup imported succesfully and everything seemed fine; however when I droppped this machine in the old ones place and booted it up, nothing happened. It would not pass any routes, and I was unable to connect to it via webadmin or any other interface.
    Do I need to type in the config by hand for this kind of upgrade?
    Any ideas would be GREATLY appreciated.

    Thanks,
    Ryan R.
Children
No Data