This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM Replacement (domain-joined)

I just upgraded our UTM SG series to a larger model. I ran setup and imported/restored the config, but now I cannot login. Is there anything extra needed for this to accept my valid domain login credentials? I do still have SSH access, but I no longer have physical access because it was just installed in a vendor's cabinet.

Thanks in advance!

This thread was automatically locked due to age.

Parents

0 the schwartz over 8 years ago

To complicate things, I used the following instructions to reset the Webadmin password, but that also reset the SSH passwords so now I'm completely locked out:

https://community.sophos.com/kb/en-us/115346#How to reset the WebAdmin and all account passwords
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 the schwartz over 8 years ago

To complicate things, I used the following instructions to reset the Webadmin password, but that also reset the SSH passwords so now I'm completely locked out:

https://community.sophos.com/kb/en-us/115346#How to reset the WebAdmin and all account passwords
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 8 years ago in reply to the schwartz

If you restore the backup, you will have SSH access. Put the backup in the root directory of a USB memory stick and reboot the device.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel