This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

yet another newbie who can't get started

I successfully installed Sophos UTM latest build, received the page that told me what the ip address was:  192.168.2.100:4444/

However, my networking capacity is limited.  I don't know how to access the GUI with a subnet different than my network.  Three PC's and Sophos device are plugged into a switch on my network.  I have a Linksys router hooked to the switch.  I tried to change the ip address of one of the PC's to 192.168.2.10 with a subnet of 255.255.255.0 and a default gateway of 192.168.1.1

This does not work.  I need to know what settings to have on one of the PC's to access that GUI on the Sophos device.  I go to network settings>network adapter>properties>internet protocol v4.  Thanks for any help to get me started...

cheers.

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

I tried to change the ip address of one of the PC's to 192.168.2.10 with a subnet of 255.255.255.0 and a default gateway of 192.168.1.1

That cannot work.

If the network is 192.168.2.0/255.255.255.0, then the gateway must be in that network; e.g. 192.168.2.1

Also, make sure you're not doing NAT on your router, see:
https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21968

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 10 years ago

I tried to change the ip address of one of the PC's to 192.168.2.10 with a subnet of 255.255.255.0 and a default gateway of 192.168.1.1

That cannot work.

If the network is 192.168.2.0/255.255.255.0, then the gateway must be in that network; e.g. 192.168.2.1

Also, make sure you're not doing NAT on your router, see:
https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21968

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data