Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 3 subscribers
  • Views 5112 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Troubleshooting Link State

Tango2
I just noticed on my dashboard that my LAN interface shows UP ERROR.  I've looked through logs and interface screens, as well as a command line ifconfig, but see nothing out of the ordinary.  The interface is set up as a static IP, 1500 MTU, and using the VMWare VMXNet 3 adapter (UTM running as VM in ESXi 5.5).

I can't find anywhere in the GUI to hard code the speed/duplex settings on an interface.  Am I missing that, or is that not available?  How can I better troubleshoot this problem?


This thread was automatically locked due to age.
Parents
  • 0
    I confirm that it's not on my 9.207-19 UTM instance in Amazon EC2, nor was it there on 9.206.35.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    I confirm that it's not on my 9.207-19 UTM instance in Amazon EC2, nor was it there on 9.206.35.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
  • 0 in reply to BAlfson
    So, link speed and duplex setting are not available on the virtual build of UTM.  Without those settings and any log entries that seem to pertain to this, what is the best method of troubleshooting this error?  What even causes this error in a virtual environment?
Cookie Information Banner