Hi All,
I wonder if someone can shed some light on a problem I have.
I have 2 Hyper-V guest ASG 8.301
I have FW1 setup and configured and working very well.
I build FW2 and gave it an IP in then internal network.
I enable HA on FW1 and thelog shows it checking the Sync interface for another ASG.
The firewall is still working fine.
I enable HA on FW2 and after a few seconds, the log shows that it has found andother ASG on the sync interface, and that FW is the master.
After a minute or so, i lose contact with FW2 and shortly after i lose contact with FW1.
If i reboot FW1 it starts up fine, but i can not connect/ping it. If I restart FW2, i see on hte console that its IP is now the same as FW1.
With either FW on, I can not ping or connect to it.
Has anyone seen this, is it something I have done? I used the Auto Configure option, and untill I set FW2 to auto configure, FW1 was working fine.
Thanks
Ian....
This thread was automatically locked due to age.
