This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridged Modem

Hi

I have a Draytek Vigor 120 Modem running in bridge mode pppoa to pppoe passthrough

And I use Astaro to make the pppoe connection, Astaro gets a dynamic IP address from my ISP.

How do I access my modem through that interface?

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 13 years ago

Hi,
you should be able to put a second IP address (different range) on that interface is oneway, but I could never get that to work.
Others have got it to work.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 wogman over 13 years ago in reply to RFCat_vk_01

I have this working at home.

What I have done is set the a host address (10.1.1.1) and gateway address (10.1.1.254) in the LAN settings on my modem, this is a different subnet from my internal network.

I've then added the gateway address I set in the modem (10.1.1.254) as an additional address on my WAN interface, created a network definition called "modem" with the modem subnet (10.1.1.0/24) and set an appropriate incoming firewall rule (modem-internal) and that has it working OK.
Cancel
Vote Up 0 Vote Down

Cancel
0 wogman over 13 years ago in reply to wogman

Sorry, one more thing. I've also set a static route on my modem for my internal address with a gateway of 10.1.1.254.
Cancel
Vote Up 0 Vote Down

Cancel
0 DJ_NZ over 13 years ago in reply to wogman

Thanks!

Ill give this a try
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 DJ_NZ over 13 years ago in reply to wogman

Thanks!

Ill give this a try
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 RFCat_vk_01 over 13 years ago in reply to DJ_NZ

Hi wogman,
I tried again without success.

1/. how did you overcome the spoof warnings?
2/. with spoof protection disabled the router resets the connection every time.

Maybe, I need to add the source address range to the modem as a valid connection, I will try and see what happens? Stupid idea.

Ian

Even with logging enabled, nothing gets displayed in the livelog except the spoofed messages when spoof checking is enabled.
Cancel
Vote Up 0 Vote Down

Cancel
0 wogman over 13 years ago in reply to RFCat_vk_01

Ian,

I'll have a look at the spoofing issue and see what I've done.
Cancel
Vote Up 0 Vote Down

Cancel
0 wogman over 13 years ago in reply to wogman

So I checked and I have spoof protection off.

I turned it on to see what the effect was and my whole network locked up [:S]

I had to restore a backed-up config to get services back.

So.......I don't have the spoofing issues 'cause spoof protection is off.
Cancel
Vote Up 0 Vote Down

Cancel