This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wan link error

I'm having a problem with my ASG v8.103 where every few days my WAN link (cable modem) shows it's status as being up, but the state as up but the status as error and I have no internet connection.  Unfortunately when this happens the only way to correct it is to turn the interface off and back on again.  Is there something I can do to prevent this from happening or to have it automatically recover itself from this situation?


This thread was automatically locked due to age.
Parents
  • Are there any of the developers of Astaro reading this ?

    I did (to be sure) a complete check of everything, tried different cabled modems, different NICs and the error is still there. I installen an ASG 7.x  and it worked.  I could not reproduce the error in 7.x but in 8.x the eth interface randomly says "error" so this has to be a software error.  Maybe a error that occuers together with specific hardware.. I dont know.. What I do know that since this error causes a total outage on everything behind the ASG it has to be classified as a MAJOR problem. 

    Can any techguy from Astaro please acknowledge that you hade read this ?

    /Mike
Reply
  • Are there any of the developers of Astaro reading this ?

    I did (to be sure) a complete check of everything, tried different cabled modems, different NICs and the error is still there. I installen an ASG 7.x  and it worked.  I could not reproduce the error in 7.x but in 8.x the eth interface randomly says "error" so this has to be a software error.  Maybe a error that occuers together with specific hardware.. I dont know.. What I do know that since this error causes a total outage on everything behind the ASG it has to be classified as a MAJOR problem. 

    Can any techguy from Astaro please acknowledge that you hade read this ?

    /Mike
Children
No Data