Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 3 subscribers
  • Views 2363 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WebAdmin failed to start

honk
hi guys,

my ASG220 reports "Services failed in runlevel 3: httpd", so my Webadmin and also ping to the ASG won't work anymore - the LAN interface is up, which i confirmed by using ifconfig on cc.

the problem appeared as i switched off all other interface (eth1, eth2, eth4 are configured) and also switched off eth0 in mistake but switched back on faster as the appliance took the change to off [:D]

hope someone has a good idea.
thanks 

jfi: runnning 8.002


This thread was automatically locked due to age.
Parents
  • 0
    thanks for reply - the webadmin itself didn't start - by entering "...S60httpd restart" i got "Webadmin stop.... done" ... "Webadmin start... done" - but the Webadmin wasn't online - when entering "...S60httpd start" i got "Webadmin start ... failed" -
    so it seems that altough the restart command itself failed the cc displayed that all went well - 

    i already reset the asg220 to factory default through panel and re-setup the device - now it seems to work fine.
    thanks
Reply
  • 0
    thanks for reply - the webadmin itself didn't start - by entering "...S60httpd restart" i got "Webadmin stop.... done" ... "Webadmin start... done" - but the Webadmin wasn't online - when entering "...S60httpd start" i got "Webadmin start ... failed" -
    so it seems that altough the restart command itself failed the cc displayed that all went well - 

    i already reset the asg220 to factory default through panel and re-setup the device - now it seems to work fine.
    thanks
Children
No Data