Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 3 subscribers
  • Views 2364 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WebAdmin failed to start

honk
hi guys,

my ASG220 reports "Services failed in runlevel 3: httpd", so my Webadmin and also ping to the ASG won't work anymore - the LAN interface is up, which i confirmed by using ifconfig on cc.

the problem appeared as i switched off all other interface (eth1, eth2, eth4 are configured) and also switched off eth0 in mistake but switched back on faster as the appliance took the change to off [:D]

hope someone has a good idea.
thanks 

jfi: runnning 8.002


This thread was automatically locked due to age.
Parents
  • 0
    in the meanwhile i noted that the eth0 lan interface disconnects itself (lost link) - and then reactivates - also using dmesg tells me that "link became ready on eth0" a regular bases - seems to be more tricky than just a malfunction webadmin

    since this a demo box where i tried to configure some settings i think i will re-setup the appliance - does anyone know how to save the config so i don't have to redo all over again?

    thanks
  • 0 in reply to honk
    Hi ,

    In the left menu:
    Management ---> Backup/restore
    Then save it or send it by mail
    [:)]

    Good luck
Reply Children
No Data