This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setup help for Pogoplug

I am having problems getting my Pogoplug to work with Astaro V 7.5.0.7
I was told that I only need to open UDP port 4365 for the Pogoplug to connect to
the service. I setup a rule for that port and it does not work. I also created a rule to open all ports for Pogoplug and still no connection is made. Can someone help me please? I am not an expert with the Astaro software configuration and need some detailed information how to get the Pogoplug service configured.

thank you


This thread was automatically locked due to age.
Parents
  • You should immediately go to 'Management >> System Settings' 'Shell Access' and take "Any" out of 'Allowed networks'!

    Only include specific IPs you want to allow access.  For customers' installations, I normally include only Astaro Support IPs, My company's primary public IP and their internal LAN.  Then I leave access disabled.  It's only turned on when Astaro Support connects to WebAdmin and enables it to do work at the command line.

    Cheers - Bob
    Also, remember that Astaro is a "stateful" firewall, so you normally don't need to have any packet filter rules allowing unrequested traffic in.  The Pogoplug is one exception.
  • Thanks, can I just create a rule to allow access from any local network computer or do I have to enter each internal IP separate. I don't need any access from the  internet since I don't have static IPs that I would connect from.
Reply
  • Thanks, can I just create a rule to allow access from any local network computer or do I have to enter each internal IP separate. I don't need any access from the  internet since I don't have static IPs that I would connect from.
Children