Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 3 subscribers
  • Views 647 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

From primary to backup interface

Martial_01
hi,

I have 1 primary (LAN) com.
Then backup is a dial up.

I understand that when it is seen that primary link is down, Astaro switch automaticaly to backup interface. Tho, dialup (=backup interface) does not start, is the init string needed?
So far I only put the phone number to call...
modem on the backup interface is a us robotics 56k?

thanks [:)]


This thread was automatically locked due to age.
Parents
  • 0
    You also need to add an initstring. See the manual of your modem to find the correct string.

    Xeno
  • 0 in reply to Xeno
    ok...

    So here is what I put as init string:
    at&l3&dt

    Here is what is in dial string:
    2345667

    Here is what is in reset string:
    at&z0

    I have also tried this:
    init string:
    at&l3&dt2345667

    dial string empty

    reset string:
    at&z0

    None of them are working. Tho while send these command with a hypertrm, it works !?! 

    thanks for your support.
Reply
  • 0 in reply to Xeno
    ok...

    So here is what I put as init string:
    at&l3&dt

    Here is what is in dial string:
    2345667

    Here is what is in reset string:
    at&z0

    I have also tried this:
    init string:
    at&l3&dt2345667

    dial string empty

    reset string:
    at&z0

    None of them are working. Tho while send these command with a hypertrm, it works !?! 

    thanks for your support.
Children
No Data