i'm deploying 2 astaros, one in my CO which is a 128MB P3-500 board with a standard eth IF as internet port, this station has IPS, a couple packetfilters, DNS proxy(DHCP lan) and a single VPN tunnel. It works perfectly, very responsive.
on the other hand, the 2nd FW is a celeron-600 with 256MB RAM which was an upgrade for the P200-96MB because ASL5 was totally unusable in that PC but now it works exactly the same on this new rig, even from the LAN side it's unusable, takes ages to open the admin, and in there you can only be browsing a couple minutes until it becomes unresponsive and then i have to open a new IE window and start over(this happens via LAN or WAN).
On this side i have a PPPoE internet(slow link, 128/512) IF and only VPN/DNS proxy.
When i check the hardware reports, the 1st FW has a usage of 0.2/0.4 in the day, the 2nd FW is always above 2/3
any ideas?.
could it be that pppoe is broken, since it's doing the same as the P200....
This thread was automatically locked due to age.