This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPP0 Interface

HI,

i would like to know how to shutdown/restart a interface (PPP0) on the console. Thx 


This thread was automatically locked due to age.
Parents
  • Under Network -> Interfaces, can you edit it, disable and then enable it?

    Not an expert here, but worht a shot....maybe. 
  • well exactly this do not work. cause nat rules are using PPPo interface. so i would like to do this with commands on the console. not on the webinterface 
  • Hello forces.

    Open /etc/wfe/conf/itf.conf in the editor of your choice.
    In the section of the ppp interface set "status = 0".
    Save. Wait 5 seconds. Set status to 1 again.

    But why do you need to restart?

    Daniel  
  • [ QUOTE ]
    Hello forces.

    Open /etc/wfe/conf/itf.conf in the editor of your choice.
    In the section of the ppp interface set "status = 0".
    Save. Wait 5 seconds. Set status to 1 again.

    But why do you need to restart?

    Daniel   

    [/ QUOTE ]

    Hi all

    What is with the follow command?
    /sbin/init.d/pppoe restart
    ..its doent work!!

    i need a hang-up command for add in the CRONTAB!
    Sorry, but your way is to pedantically for me.

    give it anohter way ?
    Who can help me please?

    Many Thanks & sorry 4 my bad english     
Reply
  • [ QUOTE ]
    Hello forces.

    Open /etc/wfe/conf/itf.conf in the editor of your choice.
    In the section of the ppp interface set "status = 0".
    Save. Wait 5 seconds. Set status to 1 again.

    But why do you need to restart?

    Daniel   

    [/ QUOTE ]

    Hi all

    What is with the follow command?
    /sbin/init.d/pppoe restart
    ..its doent work!!

    i need a hang-up command for add in the CRONTAB!
    Sorry, but your way is to pedantically for me.

    give it anohter way ?
    Who can help me please?

    Many Thanks & sorry 4 my bad english     
Children