This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

V4 boot timeout not working

Hi,

I noticed that when rebooting the firewall, it waits in the boot prompt until the enter key is pressed. I edited the lilo.conf and set the timeout to 5 and commented out the prompt line, but the timeout never ends and the machine sits there waiting for an enter, even after the default 60 seconds.

Is there any way to avoid this and make the machine boot automatically after a few seconds?

Thanks
Maurice

This thread was automatically locked due to age.

Parents

0 KKnecht over 22 years ago

I think this has something to do with your machine and is not a 'special feature' of V4.
I've never seen some behaviour like this and of course the firewall should reboot automatically ;-)

Regards,
Karsten
Cancel
Vote Up 0 Vote Down

Cancel
0 DanielC over 22 years ago in reply to KKnecht

Same here....Tried to reboot the system but it waited endlessly.
Did not try to press Enter but after a hardware reset, the system booted normally.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 DanielC over 22 years ago in reply to KKnecht

Same here....Tried to reboot the system but it waited endlessly.
Did not try to press Enter but after a hardware reset, the system booted normally.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data