This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

oversized Ethernet frame Help!!!!!!

Sometimes the Webadmin, SSH and the local console stops responding, but I can still surf...
Then after some minutes the traffic stops also and no one has access to the internet also an other Firewall which is directly connected with the cablemodem like the Astaro box.
At this time I can see on the monitor screen of the Astaro box the following line:

eth1: oversized Ethernet frame, status 0019C600

What’s this???!!!

Now I must hard reset the Astaro box and turn off and on the Cable modem.
Then everything works fine for several minutes. After I have the same problem!   

Please Help!!!   [:$]
Astaro is really a good product but i can't use it with this problem!

My Hardware is:
ASL 4.001
Compaq Desk Pro 4000
PII 233 MHz
128 MB RAM
3,2 GB HD
1 TLAN on board (LAN interface)
1 D-Link DFE-580TX 4 Port NIC
(WAN Interface, connected to the cablemodem)     


This thread was automatically locked due to age.
Parents
  • Hi,
    From what I've been reading up on that message, it might be a nic driver issue. do you have any other nics you can swap out that dlink with to verify its that card?? Also, when the nic freezes up like that, instead if rebooting the box, i beleive ifconfig-ing down and then up again should work.  When the internet becomes unresponsive, can you ping the lan interface  ?  MTU might be something to look at as well.

    the end
    jking   
Reply
  • Hi,
    From what I've been reading up on that message, it might be a nic driver issue. do you have any other nics you can swap out that dlink with to verify its that card?? Also, when the nic freezes up like that, instead if rebooting the box, i beleive ifconfig-ing down and then up again should work.  When the internet becomes unresponsive, can you ping the lan interface  ?  MTU might be something to look at as well.

    the end
    jking   
Children
No Data