Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 3 subscribers
  • Views 1153 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Network Interface Save - Synatx Error

tomk_01
Today I went to Network Interface to edit the IP address on an interface. Upon pressing save I get a systax error complaining about the interface name can't contain.... I back spaced the name out and re-entered, rebooted and still cant save the change or the origional address.

Any thoughts?

  


This thread was automatically locked due to age.
Parents
  • 0
    How does the configuration look like_ now_ (IF-Name, Type, IP-address, netmask, etc.)?
    How do you want the config look like?

    Cheers,

    Kerstin    
  • 0 in reply to Kerstin
    Interface Name = GK
    Type Standard
    IP Address 10.250.0.1
    Mask 255.255.255.0
    Gateway NONE

    Actually all I want to do is to turn on QOS. 
    But at this time once I open the interface to edit the parametres without even going iinto advanced I can't save it even without making any changes. 


       
Reply
  • 0 in reply to Kerstin
    Interface Name = GK
    Type Standard
    IP Address 10.250.0.1
    Mask 255.255.255.0
    Gateway NONE

    Actually all I want to do is to turn on QOS. 
    But at this time once I open the interface to edit the parametres without even going iinto advanced I can't save it even without making any changes. 


       
Children