This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reporting/Netrwork does not produce output

Hello,

we use ASL 2.028 and have a problem with the reporting function for the network traffic:

There is no update of the overview-traffic .pngs since we use two subnets in our internal network. Using the IP-aliases feature, we have a "eth2" and a "eth2:0" interface.

Any suggestions?

This thread was automatically locked due to age.

0 DerChris over 23 years ago

In ASL 3.2x it's a known issue that traffic accounting does not work when there's only few traffic to be counted.
Cancel
Vote Up 0 Vote Down

Cancel
0 Frank Flachenecker over 23 years ago in reply to DerChris

Is 50 to 80 Meg a day low traffic?

Frank
Cancel
Vote Up 0 Vote Down

Cancel
0 Burgui over 23 years ago in reply to Frank Flachenecker

I have the same problem. The rest of the reports works well but the network one doesn't move the day hours, it stays in 24h and some minutes. I realized that it stops working when the firewall hanged last night. Perhaps it could be restarted manually but I don't know how

Any help would be apreciated
Cancel
Vote Up 0 Vote Down

Cancel
0 oliver.desch over 23 years ago in reply to Burgui

Frank,

please check if "/var/chroot-snmp.mrtg/etc/mrtg.conf"
contains entries for the network cards.
If not run "/etc/rc.d/snmpd restart" manuallay
and check again.

read you
o|iver
Cancel
Vote Up 0 Vote Down

Cancel
0 Frank Flachenecker over 23 years ago in reply to oliver.desch

Hi Oliver,

thank you for your advice. There were entries for the network cards, also restarting /etc/rc.d/snmpd did not solve the problem.

But... when we asigned an other alias on eth0 yesterday, the accounting suddenly started to work again, just like there never have been problems.

Frank
Cancel
Vote Up 0 Vote Down

Cancel