[9.260][BUG]Kernal Panic with import of backup file?

Hi All
I Just created a new VM to migrate one Firewall to 9.3
The VM have the same HW settings.
I built the FW with a dufferent IP.
Turned off old VM.
When new VM booted and asked, I imported current backup from old 9.2.
Logged into new Webamin all OK.
Then about 30 sec later system system goes cyclic Kernal panic - not syncing Fatal exception in interrupt

I have rebuilt a number of times and get the same results each time.

Thoughts

Regards

Mark
kernel panic.zip
Parents
  • Hi Alex
    The original host is 9.2 running on vmware with 3 nics in hardware.
    In Interfaces 5 Interfaces are configured with 3 on.
    This is the only unusual config.

    The backup file was not encrypted.
    I had the original FW up did a new backup and then export to laptop.
    Built new VM with same specs.
    At IP stage put in a different IP address.
    When Up imported backup (turned off old VM).
    After about 30s - 1m machine went cyclic.
    Tried a couple more times with same results (not sure now of all the different options I tried).

    BTW When 9.3 Patch was release through normal channels. The old machine upgraded OK.
    Mark
Reply
  • Hi Alex
    The original host is 9.2 running on vmware with 3 nics in hardware.
    In Interfaces 5 Interfaces are configured with 3 on.
    This is the only unusual config.

    The backup file was not encrypted.
    I had the original FW up did a new backup and then export to laptop.
    Built new VM with same specs.
    At IP stage put in a different IP address.
    When Up imported backup (turned off old VM).
    After about 30s - 1m machine went cyclic.
    Tried a couple more times with same results (not sure now of all the different options I tried).

    BTW When 9.3 Patch was release through normal channels. The old machine upgraded OK.
    Mark
Children
No Data