I am lost I have re-installed the ISO image onto the ASG 120 4 times now. If I take the AP30 to my clients location it is detected and works fine. I plug it into our network for testing and it will not appear in the list of available APs. I am using the asg120 as a dhcp server and dns server. The AP30 is receiving an ip address but again no joy in the wireless setup. I have turned off almost every security feature I can find and still no joy. Would appreciate any and all advice on this issue.
I have the asg 120 and the AP30 connected to a Dell Powerconnect 5224 switch. I have tried to adjust the settings on the switch but I am not sure what settings to adjust.
I have the asg 120 and the AP30 connected to a Dell Powerconnect 5224 switch. I have tried to adjust the settings on the switch but I am not sure what settings to adjust.
STP should be disabled on some switches. My Problem i had with an AP10 was very similar. First thought STP is turned off already, but it wasn't. After turning it off it worked just fine.
I have the asg 120 and the AP30 connected to a Dell Powerconnect 5224 switch. I have tried to adjust the settings on the switch but I am not sure what settings to adjust.
STP should be disabled on some switches. My Problem i had with an AP10 was very similar. First thought STP is turned off already, but it wasn't. After turning it off it worked just fine.
