I am lost I have re-installed the ISO image onto the ASG 120 4 times now. If I take the AP30 to my clients location it is detected and works fine. I plug it into our network for testing and it will not appear in the list of available APs. I am using the asg120 as a dhcp server and dns server. The AP30 is receiving an ip address but again no joy in the wireless setup. I have turned off almost every security feature I can find and still no joy. Would appreciate any and all advice on this issue.
Hi, The wireless log is empty. The AP30 just does not want to show up anywhere. its the power light that just keeps flashing the wireless light stays solid. Is this a case were the AP should be sent back for a replacement? I also want to note that I received two AP30's for testing and one is setup and working perfect in a large manufacturing plant. This second one just does not want to work. The power light go's solid then blinks 23 or 24 times then go's solid then repeats cycle.
Hi, The wireless log is empty. The AP30 just does not want to show up anywhere. its the power light that just keeps flashing the wireless light stays solid. Is this a case were the AP should be sent back for a replacement? I also want to note that I received two AP30's for testing and one is setup and working perfect in a large manufacturing plant. This second one just does not want to work. The power light go's solid then blinks 23 or 24 times then go's solid then repeats cycle.
The power light go's solid then blinks 23 or 24 times then go's solid then repeats cycle.
Ok, sounds as if the AP either doesn't get an address via DHCP or cannot connect to the ASG. Could you please check your DHCP server if the AP tries to fetch an address (check for the MAC address printed on the AP itself but ignore the last digit).
