I am lost I have re-installed the ISO image onto the ASG 120 4 times now. If I take the AP30 to my clients location it is detected and works fine. I plug it into our network for testing and it will not appear in the list of available APs. I am using the asg120 as a dhcp server and dns server. The AP30 is receiving an ip address but again no joy in the wireless setup. I have turned off almost every security feature I can find and still no joy. Would appreciate any and all advice on this issue.
Ok now were starting to get somewhere I think. If I connect the AP30 directly to eth2 on the ASG120 it will find the AP30 but then I get an error that the AP30 is inactive. checking the wireless log I see this message:
recv msg: id 'A40001701EE413E', type: '2', digest: '6cf9564b7f8bb3cd4b387ad72cd9c67c466d6a68', length: '48' 2010:07:29-09:59:59 asg1 awed[9555]: AP not authorized, come back later. 2010:07:29-09:59:59 asg1 awed[9555]: send msg: type '5', digest: '630ea88148f2843979f8aa15af9d029318371c6c', length: '16' 2010:07:29-10:01:00 asg1 awed[9555]: AP A40001701EE413E timed out after 61 seconds 2010:07:29-10:10:13 asg1 awed[9555]: configuration: 1 APs and 1 networks 2010:07:29-10:10:13 asg1 awed[9555]: disconnecting client 10.10.1.253:4335 2010:07:29-10:10:26 asg1 awed[9555]: configuration: 1 APs and 1 networks 2010:07:29-10:11:18 asg1 awed[9555]: configuration: 0 APs and 0 networks 2010:07:29-10:11:26 asg1 awed[9555]: received termination signal 2010:07:29-10:11:26 asg1 awed[9555]: terminating.
Thank you for your continued suggestions and guidance. Doug.
P.S. Blinking patern is about 24 blinks then go's solid for 5 to 7 seconds.
2010:07:29-09:59:59 asg1 awed[9555]: AP not authorized, come back later.
Basically this message means that the ASG does not know the AP and you need to accept it first. The AP should be shown in the webadmin as "pending". If you click accept there it should take a minute or so and then the AP should appear as active.
2010:07:29-09:59:59 asg1 awed[9555]: AP not authorized, come back later.
Basically this message means that the ASG does not know the AP and you need to accept it first. The AP should be shown in the webadmin as "pending". If you click accept there it should take a minute or so and then the AP should appear as active.
