[8.200][BUG][FIXED] Reporting WebSecurity Application Control not working

Hello,

I set up the Application control with rule allow facebook, deny several others.

Logging in AC is enabled. I can't get any Report under Reporting-WebSecurity-AC.

Just stays empty. Searching doesn't do anything, too.

Parents

0 Scott_Klassen over 13 years ago

@Loriot: Did you just finish the 8.200 u2d install? Not saying that it is or isn't this, but it could be that the system is still busy rebuilding/converting the databases. This can take a little while after install with all of the schema changes, depending on the system load.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Scott_Klassen over 13 years ago

@Loriot: Did you just finish the 8.200 u2d install? Not saying that it is or isn't this, but it could be that the system is still busy rebuilding/converting the databases. This can take a little while after install with all of the schema changes, depending on the system load.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Loriot over 13 years ago in reply to Scott_Klassen

@Scott_Klassen: I made the update first on monday with the same result, I couldn't get any Reports under Reporting-WebSecurity-AC, also there were no entries in the Live log of the application control.Yestarday I did made a fresh installation of ASG v8.102, upgraded to v8.103, and after that I made the update to v8.2, same behavior -> no logs or reports
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel