Good evening, I started a thread on a similar subject early on in the beta test of v7.500b.
Where if you do a restore from a backup, the Network summary shows the IP address of the restored interface which is a different address to what the log and the ISP have ofr the same interface.
Good evening,
I started a thread on a similar subject early on in the beta test of v7.500b.
Where if you do a restore from a backup, the Network summary shows the IP address of the restored interface which is a different address to what the log and the ISP have ofr the same interface.
could you please tell us a step by step note how we can reproduce this? Which switch do you have in use? IS VLAN 3 configured on the switch port which is connected to the astaro? I get only state error with a hp switch if I configure a VLAN ID on the astaro which is not configured on the switch port.
could you please tell us a step by step note how we can reproduce this? Which switch do you have in use? IS VLAN 3 configured on the switch port which is connected to the astaro? I get only state error with a hp switch if I configure a VLAN ID on the astaro which is not configured on the switch port.
Greetings
Andreas
This is one of the example i tell u ,on Ethernet card i create all dummy vlan interface they are not connected to any switch ,infact there is no cable connected to card on which i created vlans
But i check with bridge and real Ethernet card with cable it doesnt show correct output (router in bridge mode with wrong ip i am not able to connect but it say link and state are up) even if u unplug cable to says up
could you please tell us a step by step note how we can reproduce this? Which switch do you have in use? IS VLAN 3 configured on the switch port which is connected to the astaro? I get only state error with a hp switch if I configure a VLAN ID on the astaro which is not configured on the switch port.
Greetings
Andreas
This is one of the example i tell u ,on Ethernet card i create all dummy vlan interface they are not connected to any switch ,infact there is no cable connected to card on which i created vlans
But i check with bridge and real Ethernet card with cable it doesnt show correct output (router in bridge mode with wrong ip i am not able to connect but it say link and state are up) even if u unplug cable to says up
