Hi friends !
dash board doesnt show correct status of interface (link and state )
even i adsl modem is off it show up
and even the interface cable is unpluged it show link
ifplugstatus
Thanks
Astaro Beta Report
--------------------------------
Version: 7.450
Type: QUESTION
State: ANSWERED
Reporter: utm_kid
Contributor:
MantisID:
--------------------------------
Cannot confirm this. Please add more information and try the latest BETA.
THX
Dominic
Good evening,
I started a thread on a similar subject early on in the beta test of v7.500b.
Where if you do a restore from a backup, the Network summary shows the IP address of the restored interface which is a different address to what the log and the ISP have ofr the same interface.
Ian M
Good evening,
I started a thread on a similar subject early on in the beta test of v7.500b.
Where if you do a restore from a backup, the Network summary shows the IP address of the restored interface which is a different address to what the log and the ISP have ofr the same interface.
Ian M
My Dearest friend Ian !
So u r also spreading SPAM ?
Thanks
I don't understand your spam comment.
Ian M
Hi,
could you please tell us a step by step note how we can reproduce this? Which switch do you have in use? IS VLAN 3 configured on the switch port which is connected to the astaro? I get only state error with a hp switch if I configure a VLAN ID on the astaro which is not configured on the switch port.
Greetings
Andreas
OK, regarding to your screenshot.
this was a result if you create all dummy vlan interface which are not connected to any switch and there was no cable connected to eth0?
I cannot reproduce it with 7.460. I took eth3 and created 3 non existing vlans. There is no physically link on eth3 and I get the correct view in the dashboard. state up and all links down
I rebooted the ASG, login/logout of webadmin and no problem exist. Could you please give me the output of ethtool eth1?
Greetings
Andreas