This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Accessing Local subnet over Remote SSL VPN Range network

Darius Sz over 7 years ago

Created SSL VPN by following the KB122769 with the following settings:

IP Host - Local subnet 192.168.3.0

IP Host - VPN Range 10.10.10.1 to .25

Under SSL VPN (Remote Access) I have Identity of Remote SSL Group and under Tunnel Access I have added local subnet

I can connect to the VPN and I can confirm that my IP is 10.10.10.5

I cannot reach any network devices on the 192.168.3.0 network. What routing setting would i need to adjust to be able to i.e. RDP to 192.168.3.100 ?

Thanks in advance

This thread was automatically locked due to age.

0 SophosNewby over 7 years ago

Did you enter any DNS info or domain info in the SSL VPN settings? I'm pretty much using the same setup and its working perfectly. Is your firewall rule at the Top?
Cancel
Vote Up 0 Vote Down

Cancel
0 shred over 7 years ago

Did you create a firewall rule to allow your ‘VPN Range’ IP host from source zone of ‘VPN’ to access your ‘Local subnet’ on destination zone ‘LAN’?

I typed up this guide on the steps I took to setup SSL VPN. Might be worth taking a quick look to see if there’s any other steps to do. I found the Sophos How-To Video incomplete but that KB article was pretty good.
Cancel
Vote Up 0 Vote Down

Cancel
0 Darius Sz over 7 years ago in reply to SophosNewby

I have a static IP that I am using to connect to the VPN. The VPN Firewall rule is not at the top but the top rule should not be preventing me from access I need.
Cancel
Vote Up 0 Vote Down

Cancel
0 Raj Thakur over 6 years ago in reply to shred

Hello there,

Is this thread still active as I am having the similar issue and have followed all the steps but still not able to access the local resources.
Cancel
Vote Up 0 Vote Down

Cancel
0 SophosNewby over 6 years ago in reply to Raj Thakur

How have you setup the SSL VPN (Remote Access ) config, have you added your local subnet to the permitted resources under Tunnel Access?
Cancel
Vote Up 0 Vote Down

Cancel
0 Raj Thakur over 6 years ago in reply to SophosNewby

Thank you for the reply. I have followed all the steps and did allow the local subnet.

I have followed the same steps mentioned in this article:

https://community.sophos.com/kb/en-us/122769

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel